![]() ![]() ![]() Press this button to simulate Standalone mode. ![]() This control is available only in Standalone mode. Changing the meter type changes the meter readings on the Amp Output component and on the amplifier output gain meters. Selects either RMS or Peak for the five meters in all channels. The fan speed varies based on the temperatures. Temperature of the amplifier's power supply. The AC Mains current being drawn by the amplifier. The AC Mains voltage, from 100 VAC to 240 VAC. (The mute controls in the Q-SYS Designer Software component are not disabled.) AC Voltage (The gain controls in the Q-SYS Designer Software component are not disabled.) Mute LockÄisables the mute controls on the front panel of the amplifier. Gain LockÄisables the gain control on the front panel of the amplifier. The individual channel Mute is disabled while the Mute All is engaged. Once Mute All is engaged, you must use the Mute All button to unmute the channels. Toggles the amplifier from Standby to Power On and back. This status also appears if the device component's Dynamically Paired property is set to 'Yes', pairing has not been assigned in Core Manager, and the device component's Is Required property is set to 'Yes'. Not Present: If applicable to the device, this status appears when the device is not connected to the network and its Is Required component property is set to 'No'.Unknown: This status appears during a Core reboot (for example, during a firmware update), or when a design is being uploaded to the Core and before it has started running.Fault: The device is malfunctioning or is not properly configured.Missing: The device cannot be discovered.Compromised: The device is functioning, but a non-fatal problem exists.Initializing: The device is in the process of a firmware or configuration update, or the design is starting.OK: The device is functioning normally.Component status is conveyed with the Status LED and Status box, which uses both color and text to indicate the current condition: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |